Thread: It has arrived
View Single Post
Old 08-22-2002, 08:58 PM  
[Labret]
Registered User
 
Industry Role:
Join Date: May 2001
Location: Са́нкт-Петербу́рг
Posts: 10,945
Stardate 11:48 EST

Big discovery at beginning of disk 3.

Instructions said to grind the "herb" and to moisten it.

Previous to disk three, I had mostly just crumbled it like joint material and barely moistened it.

I took half the usual amount, basically ground it down to very fine pieces and after inserting into disk, dunked it into a bowl of water like a teabag.

Turned the unit heat up to 260 degrees and waited for greenlight go.

After I stuck the disk in, I instantly started to see vapor developing on the little windows and in the inhalation tube. Is that a word? Anyhow, sucked it out... repeated process about 4 times as vapor collected. All same disk.

This was it, this is what it was for. Devastating. Holy. I wasnt moistening it enough before to get a good vapor. This has exceeded expectations.

damn.

I bet if I take disk 1, dunk it in water, and put it back in, it will do some damage. But not right now. Not right now.
[Labret] is offline   Share thread on Digg Share thread on Twitter Share thread on Reddit Share thread on Facebook Reply With Quote