HELP Rauter ....... fuck
 

how do you use this fucking rauter.. i am trying to set up a server and it gives me my ip 192.168.0.1 .. but thats my server ip?? i am so fucking confused , please help.. and go fuckyourself..

please specify...



Rgds,JOKER

format c:

You should set your ip address to 10.1.1.2 and your rautor
to 10.1.1.4 .. GFY is on 10.1.1.23. so that gives you class
c access to the board.

Dont forget to setup the UIW gateway (192.168.1.23)
with default packet forwarding OFF.

Thats fucked up LOL

:1orglaugh

Dont forget to set the devault gaitway which is the same
ip as the rautor.

everyone is trying to screw me up here..... fuck off all of you bitch =)

what kind of router is it?

Netgear..

format c: is not an option here ...

does it have dhcp? does your isp use dhcp or does your isp give you a static ip address?

hammer...

I must agree, hammer is an option here ...

static ip... the same ip all the time

in that case you need to set the router's ip to that adress and configure each machine on your network to use whatever the inside address of the router is (192.168.0.1 as the gateway. Or if your netgear runs dhcp, then just set each machine to obtain an ip address automatically from the router.

After you set the routers ip address, dns servers, etc. Youll either need to reboot your pc with the new settings or release and renew your ips from a dos prompt.

most likely the 192.168.0.1 is the inside ip address (not public) default gateway.