How to make a boot disk in win2k?
 

Anyone know?

To create setup disks

Insert a blank, formatted, 3.5-inch, 1.44-MB disk into the floppy disk drive.
Insert the Windows 2000 CD-ROM into the CD-ROM drive.
Click Start, and then click Run.
In the Open box, type d:\bootdisk\makeboot a: (where d: is the drive letter assigned to your CD-ROM drive), and then click OK.
Follow the screen prompts.
Important

You will need four blank, formatted, 3.5-inch, 1.44-MB floppy disks. Label them Setup Disk One, Setup Disk Two, Setup Disk Three, and Setup Disk Four.
Note

You can create the setup disks from a computer running any version of Windows or MS-DOS.

That question is pounded into your fucking head a million times on the way to the MCSE 2000...

------------------
http://thewatsonian.com/na-images/watsonianbbsrwb1.gif
Pornshare TGP - Webmasters submit here.

format c:

How To Guard Against Boot Failure With a Windows Boot Disk (Q101668)

--------------------------------------------------------------------------------
The information in this article applies to:


Microsoft Windows XP Home Edition
Microsoft Windows XP Professional
Microsoft Windows 2000 , Professional
Microsoft Windows 2000 , Server
Microsoft Windows 2000 , Advanced Server
Microsoft Windows NT Workstation versions 3.1 , 3.5 , 3.51 , 4.0
Microsoft Windows NT Advanced Server
Microsoft Windows NT Server versions 3.5 , 3.51 , 4.0


--------------------------------------------------------------------------------
When Windows is installed on a computer that has an Intel x86-based processor and the boot record for the active partition or files required to boot Windows becomes corrupted, it is not possible to boot Windows or any other operating system on that computer.

To guard against this situation, create a Windows boot disk when you install Windows on the computer. This disk is different from an MS-DOS boot disk because the entire Windows operating system cannot fit on one disk as MS-DOS can. A Windows boot disk contains the files necessary to start the operating system with the remainder of the Windows system files installed on the hard disk drive. Use the following procedure to create this disk.


Place a blank floppy disk in drive A and format the disk using Windows NT or later.


From the root folder of the system partition of your hard disk drive (for example, C:\-), copy the following files to the floppy disk: Boot.ini, NTLDR, and Ntdetect.com.

NOTE : You may have to remove the hidden, system, and read-only attributes from the files.


Restore the hidden, system, and read-only attributes to the files on your hard disk.


If either the Bootsect.dos or the Ntbootdd.sys file resides in the system partition, perform steps 2 through 4 above to copy these files to the boot disk as well.


If you format a floppy disk in Windows NT or later, the boot record points to the NTLDR file. When NTLDR runs, it loads the available operating system selections from the Boot.ini file. If the user selects Windows, NTLDR runs Ntdetect.com, and then passes control to Osloader.exe. If the user chooses MS-DOS or OS/2, NTLDR loads Bootsect.dos.