how do you use this fucking rauter.. i am trying to set up a server and it gives me my ip 192.168.0.1 .. but thats my server ip?? i am so fucking confused , please help.. and go fuckyourself..
HELP Rauter ....... fuck
Collapse
X
-
Tags: None
-
-
-
Thats fucked up LOLOriginally posted by mrthumbs
You should set your ip address to 10.1.1.2 and your rautor
to 10.1.1.4 .. GFY is on 10.1.1.23. so that gives you class
c access to the board.
Dont forget to setup the UIW gateway (192.168.1.23)
with default packet forwarding OFF.
Comment
-
-
-
-
Comment
-
-
static ip... the same ip all the timeOriginally posted by PureMeds
does it have dhcp? does your isp use dhcp or does your isp give you a static ip address?Comment
-
in that case you need to set the router's ip to that adress and configure each machine on your network to use whatever the inside address of the router is (192.168.0.1 as the gateway. Or if your netgear runs dhcp, then just set each machine to obtain an ip address automatically from the router.
After you set the routers ip address, dns servers, etc. Youll either need to reboot your pc with the new settings or release and renew your ips from a dos prompt.
most likely the 192.168.0.1 is the inside ip address (not public) default gateway.Comment

Comment