A perfect way for a dickhead felon to spends his day
-
.
Yes, fewer illegal immigrants working equates to more job opportunities for American citizens.
Rochard -
-
I made an AMD-65 a long time ago. I used an 80% receiver where I had to drill the holes and install the lower rails. Now you can get one with the rails already installed.
80% AK47 Receiver Blank - Henderson Defense Industries
I took it apart and built it again with a tapco flat. Just to see if I could do it. The best way to bend a flat is to get a press and a jig. I made a jig out of a block of wood and bent it with a hammer and another block of wood.
Both times I drilled and tapped, then screwed the receiver to the trunions. I also screwed the lower rails into place. Rivits would have looked better as well as spot welding the lower rails into place. I heat treated the rails and holes with a MAPP torch. It was ugly, But it worked. I took it apart and sold the pieces to somebody that did a better job.
Best way is to go to a build party. Where people have all the tools. BTW: There is a response video showing where the guy in the original video committed 3 felonies during his build and disposal.
Here is the response video
Comment
-
-
-
being a member of the crips, arnt you a convicted felon?Comment
-
I plan on banging the wife during lunch but that's about it for today.Herschel Savage
Brooklyn, NYComment
-
that's not ak47.
this is ak47,
Comment
-
I have built a few AR15s and always wanted to build an AK. good luck with your build!Comment
-
Nice. I'm making forty-seven zip guns to smuggle into prison.<!--BEGIN SIMUTRONICS PLAY BUTTON CODE -->
<p align="center">
<a href="http://buddy.play.net/dr?TMOREAU1">
<img src="drplay.gif" width="128" height="64" alt="Play DragonRealms!"></a></p>
<!--END SIMUTRONICS PLAY BUTTON CODE -->Comment
Comment